Sunday, May 8, 2016

Progress Report: We have Wood!

So, it's the end of week 2!
Our weekly email from our PM brought some great  news!  We had also made a trip out the day before to see the progress of our house.

It looks like they got the waterproofing and backfilling done, along with the support beams.  Plumbing had been installed too.  They haven't poured floors yet.  According to our PM, that should happen on Monday.

And then on Tuesday they should start framing.  The email from our PM said that they delivered our lumber!

Holy. Moly.

We plan on driving out daily so we can see the progress of the framing.  From what I've seen it all happens quickly.  I really want to see as much of this process as we can!

Anyways... Here's some photos from our trip out Thursday to check out the lot and progress:

Garage!  It looks like it's all prepared to pour the floors!

Near the back of the house, close to the morning room.

Inside the basement!  This view is standing at the walk-out door looking in.

Check out the plumbing!  This is standing inside the basement.

Standing in what will be the finished part of our basement.  That little part you see there will be the "exercise room" below the morning room.

Walk out.

Panoramic view standing in our basement

Basement Selfie!  Because, it's what we do!!

And finally, the view from our driveway!  It looks so different than it did the last time we were out!


So, after we got the email from our PM on Friday that our lumber had been delivered, we loaded up our Cody and Crosley and took them Saturday morning to go check out our wood! Man, was it a great sight!!!

It has OUR lot number on it!!! OURS!!


Can't tell we are exited at all, can you??

And, the view of our lot from our driveway, with our lumber all over the place!!!

We were super excited for these new additions!  Can't wait to see framing begin next week!!!!




2 comments:

  1. Love it! I totally get your excitement!!!

    ReplyDelete
  2. Very exciting! Your house will be standing before you know it!

    ReplyDelete